How a logo roller stamp works
A Rolly is a handheld logo roller engraved with your logo or text. You load it with a matched ink marker and roll it across a surface. The imprint repeats as a continuous band for as long as you keep rolling. No repositioning, no print minimums, and you can swap rolls to change the design in seconds.
Five steps to a clean band
- Step 1
Insert the marker
Slide the matched ink marker into the Rolly handle.
- Step 2
Check contact
Make sure the marker tip sits flush against the engraved roll.
- Step 3
Place it down
Set the roller flat on your surface where the band should start.
- Step 4
Roll smoothly
Roll in one steady motion, the imprint repeats as you go.
- Step 5
Don't press hard
Let the ink do the work. Light, even pressure gives the cleanest band.
Which ink for which surface?
Match the ink to your material. Alcohol ink is our recommended default, and the other inks suit specific surfaces.
Acrylic (water-based)
A matte finish. Check the marker’s material guidance before ordering.
Best for: Kraft paper, Corrugated, Mailer box, Kraft bag, Tissue paper, Packing tape, Wood, Fabric, Concrete, Brick, Iron, Metal
Alcohol
RecommendedFast-drying with crisp, opaque coverage.
Best for: Kraft paper, Corrugated, Mailer box, Kraft bag, Tissue paper, Packing tape, Wood, Fabric, Concrete, Brick, Iron, Metal
Artwork tips
- Use mostly uppercase letters. They transfer most cleanly.
- Avoid lines thinner than ~1mm and very fine detail.Avoid lines thinner than ~0.04" and very fine detail.
- Skip ultra-thin, script or heavily decorative fonts.
- Keep horizontal gaps small for a continuous-looking band.
- Send logos as vector (.svg, .eps, .ai, .pdf) for the sharpest engraving.